LSAT and Law School Admissions Forum

Get expert LSAT preparation and law school admissions advice from PowerScore Test Preparation.

 Administrator
PowerScore Staff
  • PowerScore Staff
  • Posts: 8916
  • Joined: Feb 02, 2011
|
#26015
Setup and Rule Diagram Explanation

This is a Grouping/Linear Combination, Numerical Distribution game.

This game asks us to assign each of six sections to one of three consecutive aisles. Because the aisles have an inherent order, our initial setup for the game should appear as follows:
oct12_game_3_diagram_1.png
The game scenario indicates that each aisle contains at least one section, but no maximum requirement of sections per aisle is established. Thus, the following unfixed numerical distributions of sections to aisles are possible:
  • ..... ..... ..... ..... ..... ..... 4-1-1

    ..... ..... ..... ..... ..... ..... 3-2-1

    ..... ..... ..... ..... ..... ..... 2-2-2
The remaining rules do not have further impact on the number of possible numerical distributions, and the three distributions above are the only distributions possible in the game. However, additional information can be determined about some of the distributions based on the rules.

The first rule requires R to be located in the same aisle as either F or M. Given the horizontal orientation of our setup, we need to use a vertical block to indicate identicalness or similarity:
oct12_game_3_diagram_2.png
The second rule establishes that F is located on a lower-number aisle than both M and P. Since our aisles are numbered from 1 (lowest) to 3 (highest) with numbers increasing to the right, the sequence should place M and P to the right of F:
oct12_game_3_diagram_3.png
This sequence creates three Not Laws on the diagram—an F Not Law, an M Not Law, and a P Not Law:
oct12_game_3_diagram_4.png
The third rule creates another sequence:
  • ..... ..... ..... ..... ..... S :longline: P
This sequence adds an S Not Law to the diagram (we already have P as a Not Law from the second rule):
oct12_game_3_diagram_5.png
Additionally, because both the second and the third rules contain P, they can be linked together to create a super-sequence:
oct12_game_3_diagram_6.png
The fourth rule tells us that S cannot be in a lower-numbered aisle than H:
oct12_game_3_diagram_7.png
You should immediately turn this rule into a positive statement: if S cannot be in a lower-numbered aisle than H, it logically follows that S must either be located in the same aisle as H (i.e. aisle 1 or 2), or else be in a higher-numbered aisle than H:
oct12_game_3_diagram_8.png
Either way, since S cannot be located in aisle 3, we can infer that H cannot be located in aisle 3 either. This limits which sections can be placed in aisle 3 to M, P, and R:
oct12_game_3_diagram_9.png
We can also add the last rule to our super-sequence:
oct12_game_3_diagram_10.png
While this sequence produces a number of Not Laws, it does not allow us to place any of the five variables in a particular aisle. Additionally, the vertical block is not as helpful as we would normally expect, because R’s placement relative to the rest of the variables is unknown. Finally, a closer inspection of the three Numerical Distributions reveals that only one of them (2-2-2) is sufficiently defined, which we discuss in question #15. Despite the distributions, the game is not sufficiently restricted to allow for a Templates-based approach. Thus, our final diagram looks like this:
oct12_game_3_diagram_11.png
Do not let the loosely-defined nature of this setup concern you: a quick glance at the questions reveals that the vast majority of them are Local, and as such further limit the range of possible solutions. The only Global question is question #16.
You do not have the required permissions to view the files attached to this post.

Get the most out of your LSAT Prep Plus subscription.

Analyze and track your performance with our Testing and Analytics Package.